SwRI Demonstrates Small-Scale Pumped Heat Energy Storage System

Southwest Research Institute (SwRI), in partnership with Malta, Inc. has completed assembly and commissioning of the first-of-a-kind pumped heat (or thermal) energy storage (PTES) demonstration facility. Long-duration, large-scale storage capabilities, like PTES, can help balance energy volatility and reliability issues caused by high market penetration of variable renewable energy resources such as solar and wind energy, and create solutions to fulfill worldwide carbon reduction goals.

Southwest Research Institute (SwRI), in partnership with Malta, Inc., has completed assembly and commissioning of the first-of-its-kind pumped heat (or thermal) energy storage (PTES) demonstration facility. Long-duration, large-scale storage capabilities, like PTES, can help balance energy volatility and reliability issues caused by high market penetration of variable renewable energy resources such as solar and wind energy, and create solutions to fulfill worldwide carbon reduction goals.

“One of the big problems that we face with renewable energy is balancing supply and demand,” said SwRI Group Leader Dr. Natalie Smith, the project’s lead investigator. “As the sun goes down in the evening, many people are returning home from work, turning on lights and using other electronics. This mismatch between high power demand and solar availability creates grid volatility. We want new technologies to store solar and wind power so that it can be used when the sun isn’t shining, and the wind isn’t blowing.”

A PTES system stores energy thermally in hot and cold tanks for later use. When excess wind or solar energy is being produced, the PTES runs a heat pump to make the hot storage tank hotter and the cold storage tank colder. Then, when energy demands exceed production, the PTES runs as a heat engine converting the large temperature difference between the hot and cold stored energy into electricity.

“The full-scale PTES system offers high potential system performance up to 60% round-trip efficiency and can store energy for more than 10 hours,” Smith said. “PTES is a promising, versatile technology that can be applied to many different energy sources without geological or geographical restrictions.”

Malta, Inc. is developing a full-scale commercial PTES system capable of storing energy for more than 10 hours. Under DOE-funding, SwRI developed a small-scale PTES demonstration system that uses simple recuperated cycles for both modes of operation with air as the main working fluid. The facility design is similar in basic architecture and operation to the full-scale technology and is intended to demonstrate system operability and controls strategies.

The U.S. Department of Energy supported the development of the system, which was successfully commissioned and has begun the detailed testing phase.

“We are hoping that this successful demonstration provides more confidence in this technology,” Smith said. “PTES provides a viable means to bring balance and stability to our energy usage. If we want to reduce carbon emissions, we need to integrate more renewables. Our demonstration is the pathway to that full-scale system and demonstrates commercial readiness.”

For more information, visit Long Duration Energy Storage.

No Comments Yet

Leave a Reply

Your email address will not be published.

©2022. Homeland Security Review. Use Our Intel. All Rights Reserved. Washington, D.C.